Page 3
For cord replacement: power cord must be of the same length Do not enter a pump basin after it has been used. Sewage and and type as originally installed on the Liberty Pumps product. effluent can emit several gases that are poisonous.
Page 4
Keep pump upright. the motor housing. Do not allow pump to freeze. Contact Liberty Pumps customer service to report any damage or shortage of parts. At no time shall the pump be stored within an incomplete wet basin.
Page 5
Check with the local authorities or contact Liberty Pumps if unsure of the proper basin size. Installation should be at a sufficient Switchless (Manual) Models depth to ensure that all plumbing is below the frost line.
Page 6
With pumps that are powered by fixtures to this hub. three phase electric, the phase sequence of Other Liberty Pumps basins provide a 4" caulking hub or pipe the motor must match the phase sequence grommet inlet. Hubs utilize caulking material or rubber donuts;...
Page 7
Do not reduce the discharge to below that which is provided on the pump. Larger pipe sizes may be required to eliminate friction head loss over long runs. Contact Liberty Pumps or other qualified person if questions arise regarding proper pipe size and flow rates.
Page 8
National Electric Code and applicable local Contact Liberty Pumps or other qualified person if there are codes. A disconnecting means for the pump shall be located in questions regarding proper pipe size and flow rates.
Page 9
Accidental contact with electrically live parts, items, fluid, or friction head loss over long runs. Contact Liberty Pumps or water can cause serious injury or death. other qualified person if there are questions regarding proper pipe size and flow rates.
Page 10
To do so may void the warranty. Inspect the control panel for any presence of moisture in Liberty Pumps, Inc. assumes no responsibility for damage or injury enclosure, loose connections, and general component due to disassembly in the field. Disassembly, other than an condition.
Page 12
Liberty Pumps, Inc. shall not be liable for any loss, damage, or expenses resulting from installation or use of its products, or for indirect, incidental, and consequential damages, including costs of removal, reinstallation or transportation.
Need help?
Do you have a question about the LE40 Series and is the answer not in the manual?
Questions and answers