For cord replacement: power cord must be of the same Always disconnect pump(s) from power source(s) before length and type as originally installed on the Liberty Pumps handling or making any adjustments to either the pump(s), product. Use of incorrect cord may lead to exceeding the the pump system, or the control panel.
Preparation no-hub type coupling. Connect the gravity drainage line from the fixtures to this hub. Other Liberty Pumps basins provide a 4" caulking hub or pipe RISK OF ELECTRIC SHOCK grommet inlet. Hubs utilize caulking material or rubber donuts; grommets are a simple slip-fit. Connect the gravity drainage line ...
Do not reduce the discharge to below that which is provided on the pump. Larger pipe sizes may be required to eliminate friction head loss over long runs. Contact Liberty Pumps or other qualified person if questions arise regarding proper pipe size and ...
Page 8
National Electric Code and applicable local Contact Liberty Pumps or other qualified person if there are codes. See Figure 2 for direct wire installation of 1-phase, questions regarding proper pipe size and flow rates.
Contact Liberty Pumps or other qualified person if there are questions regarding proper Do not enter a pump basin after it has been used. Sewage pipe size and flow rates.
To do so may void the warranty. oil-filled, no lubrication or other maintenance is required. Liberty Pumps, Inc. assumes no responsibility for damage or injury In the event the pump becomes clogged, the inlet screen can be due to disassembly in the field.
Liberty Pumps, Inc. shall not be liable for any loss, damage, or expenses resulting from installation or use of its products, or for indirect, incidental, and consequential damages, including costs of removal, reinstallation or transportation.