General Use; Connections - Hegel H120 User Manual

General Use

Operating the H120
The source and volume can be changed
using the input and volume selector on the
front panel or using the remote control.
Power Button
The H120 amplifier can be switched on and
off with the power button located on the un-
derside of the amplifier, towards the front of
the unit.
NOTE: When powering up, the H120 takes
a few seconds to calibrate, the outputs are
muted and the volume flashes to indicate
that mute is on. This is normal and is part
of the start-up procedure.
NOTE: When the H120 has been switched
off, wait 30 seconds before powering it on
again.
10
Headphone Output
Connect the 6.3mm headphone jack to
the front of the H120. This activates the
headphone volume control and mutes the
speaker outputs.
NOTE: Variable Line Output is still active.
Sleep/Auto standby
In compliance with the EU Energy Efficiency
Directive the Hegel device will automatically
switch off after 15 minutes without sens-
ing a signal, or with very low signal on the
speaker outputs. You can disable or change
the Sleep/ Auto Standby settings in the
device's menu.

Connections

Right Speakers
Amplifier circuit protected by Hegel US Patent No 6.275.104
Line Output Unbalanced Inputs Balanced Inputs
Variable Analog 1 Analog 2 Right Left
Left
Right
Always power the amplifier off before con-
necting input/output audio cables and the
power cable.
Speakers
• Right outputs
• Left outputs
Line Outputs
• Variable Line Level (RCA)
Analog Inputs
• Balanced (XLR): Standard balanced
analog input (Pin 1 is Chassis Ground;
Pin 2 is Positive Phase; Pin 3 is Negative
Phase)
• Analog 1(RCA): Standard analog input
• Analog 2(RCA): Standard analog input
If you want to connect the amplifier to a
Home Theater system, see Device Menu.
Left
Serial number
H120 Integrated Amplifier,
Hegel, Oslo, Norway
230VAC Fuse: 4AT
Digital Inputs
Coaxial Optical 1 Optical 2 Optical 3 USB Network
Apparatet må tilkoples jordet stikkontakt
A 46 R
AC Power Connection
• AC Power connector with fuse holder:
230V/115V/100V AC depending on
country.
Digital Connections
• Coax1: Input Coaxial/RCA
• Optical1: Input TOSLINK/EIAJ Optical
• Optical2: Input TOSLINK/EIAJ Optical
• Optical3: Input TOSLINK/EIAJ Optical
• Computer USB input
• Home network connection (LAN - RJ45)
11