Robertshaw RS8210 Installation Manual page 16

TECHNICIAN SETUP MENU
Feature Feature Description
This feature will flash FILT in the display
Filter
after the elapsed run time to remind
the user to change the filter. A setting of
Change
"off" will disable this feature.
Reminder
This feature allows the installer to
Room
change the calibration of the room
Temperature temperature display. For example, if the
thermostat reads 70°F and you would
Calibration
like it to read 72°F then select +2.
This feature allows the installer to
select the minimum run time for the
compressor. For example: A setting
Minimum
of 4 will force the compressor to run
Compressor
for at least 4 minutes every time the
On Time
compressor turns on, regardless of the
room temperature.
14
LCD will show Adjustment Options
You can adjust the filter change
Next Step
reminder from OFF to 2000 hours of
Filter
Filter
run time in 50 hour increments.
Prev Step
Done
You can adjust the room
Next Step
temperature display to read - 3°F
Set At
Set At
to 3°F above or below the factory
Prev Step
calibrated reading.
Done
You can select the minimum
compressor run time from OFF, 3, 4,
or 5 minutes, if 3, 4, or 5 is selected,
Next Step Min Com On
the compressor will run for at least
the selected time before turning off.
Prev Step
Done
Factory default
settings