Protective Cap - Bernard TG Series Owner's Manual

NOTE:
Ensure power supply is off and gun is removed from feeder before proceeding.

Remove nozzle, tip and retaining head.

If power pin is thread-in liner type, using a 10 mm wrench, turn thread-in liner retainer counterclockwise until
liner is free from the power pin.

With gun straightened, grip conduit liner with pliers and remove.
STEP #2

Feed replacement liner through gun using short
strokes to avoid kinking. Twist liner clockwise if
necessary.

Using a 10 mm wrench, turn thread-in liner
retainer in a clockwise direction and tighten in
power pin.
3.3 TREGASKISS QUICK LOAD™ LINER REPLACEMENT
STEP 1

Remove consumables (nozzle, contact tip and
retaining head).

Pull existing Tregaskiss QUICK LOAD Liner
from neck using pliers.
STEP 2

Remove the protective cap from the new
Tregaskiss QUICK LOAD Liner.
STEP 3

Insert the liner through the neck using the wire
as a guide. Push the liner in using short
strokes to prevent the wire from kinking.
STEP #3
LINER
LINER GAUGE

Push liner back into gun and hold in place.
 Using liner gauge, trim conduit liner with 3/4" (19
mm) stick out.

Remove any burr that may obstruct wire feed,
especially on flat wire type conduit liner.

Replace nozzle, tip and retaining head onto
gooseneck.
TREGASKISS
QUICK LOAD LINER
LINER
17
3/4" (19 mm)

PROTECTIVE CAP

NECK