3.7 NECK REPLACEMENT – XS GUN MODELS
STEP #1
Place neck in vise.
Twist handle nut and pull away from handle.
Slide handle back exposing jam nut and front of unicable.
Loosen jam nut using two 3/4" (19 mm) wrenches and unthread neck.
Remove from vise and unthread neck by hand.
HANDLE
STEP #2
LOCK NUT
Install handle lock nut on neck.
Thread jam nut onto new neck.
Thread neck into unicable (hand tighten) to desired orientation.
Place neck in vise and tighten unicable and jam nut.
Reposition handle and switch.
Reinstall handle lock nut.
3.8 UNICABLE REPLACEMENT
The unicable in this gun can only be replaced by ordering a replacement gun chassis. Please refer to the
Standard Parts Chart on the last page of this Technical Guide.
NECK
JAM
UNICABLE
HANDLE
NUT
LOCK NUT
JAM NUT
UNICABLE
NECK
20
SWITCH