Vision TM-CAGE Owner's Manual page 9

7. Attach projector ceiling or wall mount.
8. Route cables down the projector bracket and plug in to projector.
9. Turn the projector on. Adjust the pitch and roll of the projector and tighten
adjustment bolts.
10. Fit access prevention collars
Gently locate in the notch at each end of the long side, then slide into place. The
8mm hole on the top surface should be directly over the 8mm hole in the top plate.
Note: This step is done
with the projector bracket
already in place in the
ceiling.
Vision brackets attach to the
TM-CAGE top plate with the
pin-hex security bolts which
come with Vision brackets.
7