Selecting Operating Mode - ABB TZID-C Operating Instructions Manual

7. Adjust the tolerance band (only necessary for critical actuators, e.g. especially small ones).
See "P1.2 Tolerance band" on page 55. Usually, this step is not required.
8. If required test the settings. See "P1.3 Test" on page 56 for details.
9. Save the settings:
- Press and hold
- In addition, briefly press
- Release
MODE
- Select NV_SAVE using
- Press and hold
The settings are saved in the non-volatile memory, and the positioner returns to the operat-
ing level. The last previous operating mode is activated again.

Selecting operating mode

Mode 1.0: Adaptive control
• Press and hold
MODE
• Additionally briefly press
°
C
%
•
mA
conf
• Release
MODE
°
C
%
• mA
conf
Mode 1.1: Fixed control
• Press and hold
MODE
• Additionally briefly press
°
C
%
mA
•
conf
• Release
MODE
°
C
%
• mA
conf
c
.
MODE
until P1.4 is indicated.
.
or .
until the countdown is completed, then release
ENTER
.
as often as required.
is displayed.
.
is displayed, adaptive control is running.
.
as often as required.
is displayed.
is displayed, fixed control is running.
Brief operating instructions
Brief operating instructions
ENTER
42/18-64-4 EN
.