HUSTLER Super S General Service Manual page 42

10. Install the belt guide shoulder bolt. Make sure the belt
is routed between the shoulder bolt and the pulley.
Figure 6-11
11. Install the deck covers. Figure 6-10
12. Attach the negative battery cable.
Never operate the mower without the deck covers
in place.
36" Deck shown
A
B
C
A. Spindle pulleys
B. Deck drive belt
Figure 6-14
REV A
A
C. Idler pulleys
A. Electric clutch pulley
48"/52"/60" Deck Belt Replacement
Allow the engine and muffler to cool before
proceeding with the following procedure.
Exercise caution when releasing spring tension
from the belt idler.
1. Before proceeding perform the following sequence:
• Always stop on level ground.
• Disengage the deck clutch.
• Place the steering control levers in the neutral
position.
• Place the park brake lever in the engaged park
brake position.
• Stop the engine.
• Remove the ignition key.
• Wait for the engine and all moving parts to come
to a complete stop.
• Disconnect the negative battery cable.
2. Lower the deck to the lowest setting.
3. Remove the deck covers. Figure 6-16
6-6
A
Figure 6-15
127180