HUSTLER Super S General Service Manual page 27

A
B
FULLY ASSEMBLED
A. Top cap
Figure 4-29
2. Place mower securely on jack stands and do not allow
the mower to move. Chock the drive wheels.
• Use only certified jack stands. Use only
appropriate jack stands, with a minimum
weight rating of 2000 pounds (907 kg) to
block the unit up.
• Use in pairs only.
• Follow the instructions supplied with the
jack stands.
3. Remove the wheel from the fork by removing the axle
bolt, flat washers, and lock nut. Figure 4-30
4. Remove the dust caps and bushings from the wheel
housing. Retain these parts. Figure 4-31
5. Remove and discard the seals. Figure 4-31
127180
B. Plug
B
C
A. Wheel
B. Fork
C. Axle bolt
6. Remove and discard the tapered roller bearings and
outer bearing races. Figure 4-31
C
A
B
A. Dust cap
B. Bushing
7. To prevent contamination of the new tapered roller
bearings remove the existing grease from the wheel
housing.
4-15
D
D
D. Flat washer
E. Lock nut
Figure 4-30
C
D
D
C. Seal
D. Bearing & outer race
Figure 4-31
E
A
A
B
REV A