[Power Management] - NEC PE506UL User Manual

• Please remember your new PIN code and keep it safe.
To cancel the PIN code
(1) While simultaneously pressing the POWER button and the ENTER button on the projector, plug the power cord
into the projector. After a while keep pressing the button, the PIN code input screen appears. Enter "111".
(2) Select On-Screen menu [Security] >> [PIN code lock] >> "On". As the input screen appears again, enter the
default value (111) and set the PIN code to "off" or set a new PIN code.
Expand
Language
Auto setup
Keystone
Security
Power management
Filter
Test pattern
Network setup
Control ID
Factory default

[Power management]

To reduce power consumption and maintain life cycle of light source, the power management function will turn off
the projection light source if your projector has no signals for a period of time.
1) Press ▲ ▼ button to select [Power management] menu.
2) Press the ENTER button.
3) Press ▲ ▼ button to switch required item.
Ready...... The power light indicator turns steady green when the light source is fully cooled down. The light source
turns on again if an input signal is connected or any button (except the power button ) on the top control
panel or remote control is pressed during this period of time.
Shut down......The projector shut down after the light source is fully cooled down.
Off......Disable the power management function.
Timer...... Once the input signal is interrupted and no buttons has been pressed for 30 seconds afterwards, the "No
signal" message displays in the timer. The timer counts down until the light source turns off. Press arrow
button to set up the timer in range of 1~30 minutes.
Ready countdown...... Set the interval from the Ready mode change to the Standby mode (0 to 30 minutes) auto-
matically.
NOTE:
• Factory default for standby time: 5 minutes. Count down for ready mode: 5 minutes.
• When selecting [Off], the [Timer] and [Ready countdown] is unavailable.
• When selecting [Shut down], the [Timer] is unavailable.
. . .
When it is set it to zero, the projector will never change automatically. Press the Power but-
ton to change your projector into the Standby mode and press any other button (except the
Power button) to power on.
Expand
Security
PIN code lock
PIN code change
52
5. Using On-Screen Menu
Off