Table of Contents
Advertisement
5. Turn off both power switches and connect the power cords (
).
FIGURE 1-19
Make sure both power switches on the back of the controller module are turned off
(0). Connect both power cords (that you routed from the power sequencers on
page 7) to the power connectors on the controller module.
Power switches
Power cords
Power Switch and Power Cord Locations
FIGURE 1-19
Chapter 1
Installation
23
Advertisement
Table of Contents
Need help?
Do you have a question about the RSM Array 2000 and is the answer not in the manual?
Questions and answers