Table of Contents
Advertisement
4.7 Cable Fabrication and Connector Assembling in
Hull Unit (incl. receiver unit)
Assembling 38P connector (CN-C1, CN-C3, CN-C4)
20P connector (CN-C2)
Fabrication of cable for 38P and 20P connectors
Shield
Vinyl sheath
Core
Figure 4-18 Fabrication of cable for 38P and 20P connectors
Assembling the 38P connector
1. Bundle unused wires outside the connector case.
2. Fix the cover 1, noting the cable outgoing direction.
3. Dress the wires and fix the covers 2 and 3. Use a fragment of cable
sheath to fix the wires at the cable clamp.
4. Shorten unused wires and tape their ends with vinyl tape to prevent short
circuit.
Fragment of
anticorrosive sheath
Insulate unused
wires with vinyl
tape.
CN-C1, CN-C3
200
Anticorrosive
45
sheath
40
Armor
Insulating tape
Expose cores; wind
shield around armor.
Cover 3
Guide pin
Cover 2
Figure 4-19 How to assemble the 38P connector
CN-C2, CN-C4
L
Shield
Vinyl sheath
Core
Fold back shield
onto armor.
Guide Pin A
Cover 1
Position No.
Guide Pin A
(Large)
4-11
Anticorrosive
45
sheath
40
Armor
L = 200 (CN-C2)
250 (CN-C4)
Insulating tape
Cable outgoing
direction
Guide
Pin B
Guide Pin B
(Small)
Advertisement
Table of Contents
