Table of Contents
Advertisement
4.6 Cable Fabrication and Connector Assembling in
Transmitter Unit
Assembling 38P connector (CN-B2, CN-B3, CN-B4)
Fabrication of cables 10S1258-1, 10S1260
300
Shield
Vinyl sheath
Figure 4-14 Fabrication of cables 10S1258-1, 10S1260
Assembling the 38P connector
1. Bundle unused wires outside the connector case.
2. Fix the cover 1, noting the cable outgoing direction.
3. Dress the wires and fix the covers 2 and 3. Use a fragment of cable
sheath to fix the wires at the cable clamp.
4. Shorten unused wires and tape their ends with vinyl tape to prevent short
circuit.
Guide pin
Fragment of
anticorrosive sheath
Insulate unused
wires with vinyl
tape.
45
40
Anticorrosive sheath
Armor
Cover 3
Cover 2
Figure 4-15 How to assemble the 38P connector
Core
CN-B4: Fold back shield
CN-B2, B3: Expose cores;
Guide Pin A
Cover 1
Position No.
Guide Pin A
(Large)
4-9
Insulating tape
onto armor.
wind shield
around armor.
Cable outgoing
direction
Guide
Pin B
Guide Pin B
(Small)
Advertisement
Table of Contents
