Table of Contents
Advertisement
3.3 Mounting the Transmitter Unit
The transmitter unit can be mounted with or without mounting legs. For use without mounting
legs remove them and use inside mounting holes.
Reinforce the transmitter unit against vibration by stays extending from the eyebolts on the top
of the unit.
3.4 Mounting the Power Unit
The power unit can be installed in any dry, well-ventilated place.
3.5 Mounting the Interface Unit
The interface unit connects with several navigation and fishing equipment, so determine the
installation site with the wiring to them taken into account. Furthermore, the unit incorporates
a data selector and self-check switch, therefore select a place where they can be easily operated.
3.6 Mounting the FNZ Joint Box
The FNZ joint box interchanges both Tx trigger and sounder marker pulses from the echo
sounder and the net sonde. Therefore, install it as close as possible to the net-sonde indicator.
Figure 3-11 Transmitter unit
3-8
Attach stay to
this eye bolt.
Mounting leg for
outside leg mounting
For mounting without legs,
remove legs and use inside
holes for mounting.
Advertisement
Table of Contents
