Other Menu Description - Furuno Marine Radar Operator's Manual

3.10 OTHER MENU Description

The following summarizes the OTHER MENU.
Item
1. Panel Dimmer
2. Mark Brill
3. HD Mark
4. Charactors
5. Trail Tone
6. Int Reject
7. Pulselength
8. Noise Reject
9. Trail Time
10. Tune
11. Disp Data
12. WPT Mark
13. EBL Ref
14. VRM Unit
15. Watchman
16. STBY Disp
17. Guard Mode
18. Own Position
19. Cursor Posi
20. Alm sense LV
21. Dead Sector
22. Range
23. Self Test
24. Installation Setup
18
Table 3-2 OTHER MENU Description
Select level of panel backlight.
Select brilliance of VRM, EBL, cursor, guard zone and WP marks.
Select brilliance of heading mark.
Select brilliance of charactors.
Select brilliance of echo trails.
Select level of interference rejection.
Select pulselength for 1.5 and 3 mile ranges.
Select "On" to reject noise.
Select the trail time.
Select automatic or manual tuning.
To tune manually;
1. Select "Menu" by the omnipad.
2. Press the [ENTER] key to enable manual tuning.
3. While pressing and holding down the [GAIN] control, operate
the omnipad.
4. Press the [ENTER] key.
"MANUAL" appears at the top right-hand corner when manual
tuning is in effect.
Select the down sourse to display.
Select "On" to display the waypoint mark.
select EBL reference for relative or true.
Select distance unit of VRM and cursor for nm, km or sm.
Turn watchman on (set rest period) or off.
Select the display on stand-by; display "STBY" or navigation data,
or go into the economy mode.
Select condition which triggers guard alarm; in or out.
Display the cursor position in strength whitch trigger guard alarm.
Dispalay the cursor position in range/bearing or lat/long.
Select minimau echo strength which triggers guard alarm.
Select "On" to display the dead sector.
Select ranges in use.
Test keys, ROM and RAM, check antenna rotation speed, and
display program no.
Go to the installation setup menu.
Description