Installation Instruction; Step 1-Stick Sponge (Sealing Strip) And Sponge On The Outdoor Unit; Step 2-Selecting An Installation Location & Installing The Roof Top Air Conditioner - Sinclair ASV-35BS User Manual

Wi-fi camper trailer
Table of Contents

Advertisement

BEFORE INSTALLATION
Test run the unit with proper power supply. Refer to the operation instruction section in the Owner's
Manual Operation & Installation. Make sure all the controls operate correctly then disconnect the
power supply of the unit.
1. Moving parts may cause personal injury. Be careful when test the unit. Do not operate the unit
with exterior cover removed.
2. Outdoor unit can't be installed at the low recess of the roof of vehicle. It must be mounted at the
flat surface on the roof of vehicle to make sure the rain, car-washing water, condensate water,
etc. can be drained smoothly. No water is allowed to be accumulated around the outdoor unit;
otherwise, it will cause malfunction or safety hazards as the water will pour into the air conditioner.
3. Please use the equipped mounting Plate for installation; otherwise, it may cause malfunction
or damage.
1.
Before sticking, clean up the sundries
at the sticking position (as shown in
Figure 1) of the chassis of the outdoor
unit to ensure that the sticking position
is clean;
2.
Take out one piece of sponge (sealing
strip) and three pieces of sponge from
the accessories, and tear off the paper
on the glue surface and align at the edge
of the position as shown in Figure 1 to
stick the sponge.
If the sponge (sealing strip) is damaged
or not stuck on the proper position, you
must replace it with a new one and stick
it properly;
3.
Check whether the sponge (sealing strip)
and the sponge are tightly adhered, and
ensure that they will not fall off.
STEP 2-SELECTING AN INSTALLATION LOCATION &
INSTALLING THE ROOF TOP AIR CONDITIONER
Your air conditioner has been designed for use in recreational vehicles.
Check the roof of the vehicle to determine if it can support both the roof top unit and the ceiling
assembly without additional support. Make sure the interior ceiling mounting area will not
interfere with existing structures.
INSTALLA TION
WARNING
Sticking position
of sponge
(sealing strip)
Sticking position of
three pieces of sponge
- 10 -
Figure 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asv-25bs

Table of Contents