Table of Contents
Advertisement
TURBO button
Under COOL or HEAT mode, press this button to
turn to quick COOL or quick HEAT mode. "
icon is displayed on remote controller. If start this
function, the unit will run at super-high fan speed
to cool or heat quickly so that the ambient tem-
perature approaches the preset temperature as
soon as possible.
NOTE
●
Fan Speed "
" is unavailable for some models,
Fan Speed "
" is the same with Fan Speed "
for some models.
Function introduction for
combination buttons
Child lock function
Press "+" and "-" simultaneously to turn on or
turn off child lock function. When child lock func-
tion is on, "
" icon is displayed on remote control-
ler. If you operate the remote controller, the "
icon will blink three times without sending signal to
the unit.
Temperature display switchover function
Under OFF status, press "-" and "MODE" buttons
simultaneously to switch temperature display
between
and
.
℃
℉
WiFi function
Press "MODE" and "TURBO" button simultane-
ously to turn on or turn off WiFi function. When
WiFi function is turned on, the "WiFi" icon will be
displayed on remote controller; Long press
"MODE" and "TURBO" buttons simultaneously
for 10s, remote controller will send WiFi reset
code and then the WiFi function will be turned on.
WiFi function is defaulted ON after energization
of the remote controller.
NOTE
●
This function is only available for some models.
Replacement of batteries in
remote controller
"
signal sender
Press the back side of remote controller
1.
"
marked with "
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
2.
make sure the position of "+" polar and "-" polar
are correct.
3.
Reinstall the cover of battery box.
NOTICE
●
During operation, point the remote control signal
sender at the receiving window on indoor unit.
●
The distance between signal sender and receiving
window should be no more than 8m, and there
"
should be no obstacles between them.
●
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
●
Replace new batteries of the same model when
replacement is required.
●
When you don
please take out the batteries.
●
If the display on remote controller is fuzzy or there
no display, please replace batteries.
- 8 -
battery
reinstall
remove
Cover of battery box
", as shown in the fig, and then
'
t use remote controller for a long time,
'
s
Advertisement
Table of Contents
