maximuscle 335 / 8687 Assembly & User's Instruction page 18

Assembly Instruction
Step 12
Important: Study and following the diagram and below Cable Loop Diagram carefully:
a. Feed the bolt's end of the Upper cable (38)
Through the pulley bracket on the top of the
Upper frame (5), Attach one Pulley (65) to the
Bracket. Fix using one M10 x 45mm Allen Bolt
(79), two Ø10mm Washers (93) and one M10
Aircraft nut (95).
b. Draw the cable backward and through the
bracket on the top of the Upright support (3)
repeat above step to install a pulley on the
bracket.
c. Draw the cable frontward around a Pulley
(65) then place the pulley into the center of the
Front press base (6), fix using one M10 x
180mm Allen Bolt (80), two Ø10mm Washers
(93) and one M10 Aircraft nut (95).
d. Draw the cable backward through the hole
on the Upright support (3), attach one Pulley
under the cable, repeat step a to install the
pulley to the bracket on the back of the Upright
support (3).
e. Draw the cable downward, place one Pulley
(65) onto the cable and fit Pulley cover (66)
over the pulley and the cable. Attach the
Pulley assembly to the Double floating pulley
bracket (28) using one M10 X 45mm Allen Bolt
(79), two Ø10mm Washers (93) and one M10
Aircraft nut (95).
NOTE: Let the Pulley (65) and Double floating
pulley bracket (28 ) handing at this stage.
f. Draw the cable upward around the pulley
then attach the pulley to the opening on the
rear of the Upper frame (5), fix using M10 x
68mm Allen bolt (81), two
bushings (72) and one M10 Aircraft nut (95).
g. Draw the end of the cable downward and
secure the end bolt into the upper opening of
the Weights select rod (23).
NOTE: Tighten or loose the end bolt of the
Upper cable (38) can adjust the tension of the
cable system. Please make sure the bolt
screw inside of the Weight select rod (23) at
list 5 laps.
17
25X15mm Pulley