Assembly Instruction
Step 4
a. Carefully slide 14PCS Weight stacks (69)
down Guide rods (22).
Important: The deep grooves on the Weight
stacks (69) MUST all face the back of the
assembly and be on the underside.
b. Insert the Weights select rod (23) down
through the center hole of the Weight stacks
(69). Ensure the pin of the Weights select rod
(23) is on the notches of the top weight stack.
Attach the "Rings" of Weight select pin (41) to
the top of the Weights select rod (23). Slide
Weight stem (68) down to the Guide rods (22).
When using: Select the desired training weight
by inserting the Weights select pin (41) into the
deep grooves under the Weight stacks and into
the Weights select rod (23).
When not in using: Insert the Weight select pin
(41) into the lock ring on the U-shaped bracket
(30).
.
Note: Each Weight stack approximately 4.5Kgs
Refer the weight resistance chart on Page 37
9
: