Furuno 1715 Operator's Manual page 31

3. INSTALLATION
10. Connect the 9-pin connector of the
antenna cable to J801. See the illustration
on the previous page for location.
11. Refasten the shield plate with 10 screws.
Be sure not to pinch the cable from the
rotation detector with the shield plate.
12. Fasten the EMI core fixing plate with
screw (supplied).
Align bend with
corner of chassis.
EMI Core
Fixing Plate
How to fix the EMI core
13. Temporarily close the cover. You will need
to open the cover later to confirm
magnetron voltage.
Mounting using the optional mounting
bracket
A mounting bracket for fastening the antenna
unit to a mast (70-125 mm diameter) on a
sailboat is optionally available.
Type OP03-93, Code 008-445-080
Contents of mounting bracket kit
Name Type
Bolt M4 x 12
Bolt M8 x 20
Mounting
03-018-9001-0
plate
Support
03-018-9005-0
plate (1)
Support
03-018-9006-0
plate (2)
Bracket (1) 03-028-9101-0
Bracket (2) 03-028-9102-0
Fixing plate 03-028-9103-0
Screw (M4 x 15)
EMI Core
Code No. Qty
000-804-725 4
000-805-707 8
100-206-740 1
100-206-780 1
100-206-790 1
100-206-810 1
100-206-820 1
100-206-830 2
24
1. Remove mounting hardware at the
bottom of the antenna base. You may
discard the mounting hardware.
2. Assemble the mounting bracket as below
and fasten it to a mast.
3. Fasten the antenna unit to the mounting
bracket with hexagon head bolts (M10 x
25, optional supply).
M8 x 20
M8 x 20
Fixing plate
Bracket (2)
M8 x 20
(A) Assembling the mounting bracket
M10 x 25
(B) Fastening antenna to mounting bracket
How to assemble the optional mounting
bracket and mount the antenna
4. Open the cover.
5. Follow steps 5-12 in "Mounting on a
platform."
Mounting plate
Bracket (1)
Support
plate (2)
Support
plate (1)
M4 x 12