Connectors - Sony KDL-26U4000 Service Manual

21 Pin Connector (SCART)
21
19
17
15
13
11
9
7
5
3
1
WARNING (UK Models only)
The flexible mains lead is supplied connected to a B.S. 1363 fused
plug having a fuse of the correct rating for the set. Should the fuse
need to be replaced, use a fuse of the same rating approved by ASTA
to BS 1362, ie one that carries the
IF THE PLUG SUPPLIED WITH THIS APPLIANCE IS NOT SUITABLE
FOR THE OUTLET SOCKETS IN YOUR HOME, IT SHOULD BE CUT
OFF AND AN APPROPRIATE PLUG FITTED. THE PLUG SEVERED
FROM THE MAINS LEAD MUST BE DESTROYED AS A PLUG WITH
BARED WIRES IS DANGEROUS IF ENGAGED IN A LIVE SOCKET.
When an alternative type of plug is used, it should be fitted with the
correct rating fuse, otherwise the circuit should be protected by the
same rating fuse at the distribution board.
All manuals and user guides at all-guides.com

CONNECTORS

Pin No
20
18
16
14
12
10
8
6
4
2
UK PLUG WARNING
mark.
T
ASA
- 5 -
1 2 Signal
1 Audio output B Standard level : 0.5V rms
(right) Output impedence : Less than 1kohm*
Audio input B Standard level : 0.5V rms
2 (right) Output impedence : More than 10kohm*
Audio output A Standard level : 0.5V rms
3 (left) Output impedence : Less than 1kohm*
4 Ground (audio)
5 Ground (blue)
6 Audio input A Standard level : 0.5V rms
(left) Output impedence : More than 10kohm*
7 Blue input 0.7 +/- 3dB, 75 ohms positive
High state (9.5-12V) : Part mode
8 Function select Low state (0-2V) : TV mode
(AV control) Input impedence : More than 10K ohms
Input capacitance : Less than 2nF
9 Ground (green)
10 AVlink
11 Green Green signal : 0.7 +/- 3dB, 75 ohms,
positive
12 Open
13 Ground (red)
14 Ground (blanking)
_ _ Red input 0.7 +/- 3dB, 75 ohms, positive
15
_ (S signal Chroma 0.3 +/- 3dB, 75 ohms, positive
- -
input)
16 Blanking input High state (1-3V) Low state (0-0.4V)
(Ys signal) Input impedence : 75 ohms
17 Ground (video
output)
18 Ground (video
input)
19 Video output 1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
Video input 1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
20
Video input 1V +/- 3dB, 75ohms, positive sync 0.3V
- -
Y (S signal) (-3+10dB)
21 Common ground
(plug, shield)
Connected Not Connected (open)
Signal level
* at 20Hz - 20kHz
How to replace the fuse.
Open the fuse compartment with
a screwdriver blade and replace
the fuse.
FUSE