Page 1
RM-ED009 RM-ED009 KDL-26B4050 KDL-26B4050 RM-ED009 RM-ED009 Note: This Service Manual shows only the differences from KDL-20/23/26B4030. Refer to the Service Manual (9-927-595-xx) of KDL-20/23/26B4030, also for repair. KDL-20B4050 / KDL-23B4050 / KDL-26B4050 RM-ED009 FLAT PANEL COLOR TV - 1 -...
Page 2
COMPONENTS IDENTIFIED BY SHADING AND MARKED THE SCHEMATIC DIAGRAMS, EXPLODED VIEWS AND IN THE PARTS LIST ARE CRITICAL FOR SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
Page 3
SECTION 5 EXPLODED VIEWS NOTE : Non-serviceable items with no part number and no Items marked “*” are not stocked description are not stocked because they are not since they are seldom required for required for routine service. routine service. Some delay should be anticipated when ordering these The construction parts of an assembled part are indicated with a collation number in the remarks column.
Page 4
5-2. CHASSIS (26 inches) SECTION 5 EXPLODED VIEWS NOTE : Non-serviceable items with no part number and no Items marked “*” are not stocked description are not stocked because they are not since they are seldom required for required for routine service. routine service.
DUE TO LIVE CHASSIS, THE CHASSIS OF THIS RECEIVER IS PARTS LIST ARE CRITICAL FOR SAFE OPERATION. REPLACE DIRECTLY CONNECTED TO THE POWER LINE. THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
Due to the higher melting point of Lead Free Solder the soldering iron tip temperature needs to be set to 370 degrees centigrade. This requires soldering equipment capable of accurate temperature control coupled with a good heat recovery characteristics. For more information on the use of Lead Free Solder, please refer to http://www.sony-training.com - 3 -...
RM-ED009 CONNECTORS 21 Pin Connector (SCART) Pin No Signal Signal level Audio output B Standard level : 0.5V rms (right) Output impedence : Less than 1kohm* Audio input B Standard level : 0.5V rms (right) Output impedence : More than 10kohm* Audio output A Standard level : 0.5V rms (left)
Page 13
RM-ED009 HDMI Connector Pin No Signal Assignment Pin No Signal Assignment TMDS Data2+ TMDS Clock Shield TMDS Data2 Shield TMDS Clock- TMDS Data2- TMDS Data1+ Reserved (N.C. on device) TMDS Data1 Shield TMDS Data1- TMDS Data0+ DDC/CEC Ground TMDS Data0 Shield +5V Power TMDS Data0- Hot Plug Detect...
RM-ED009 SE2 SELF DIAGNOSTIC SOFTWARE The identification of errors within the SE2 chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty.
RM-ED009 SECTION 3 CIRCUIT ADJUSTMENTS 3-1. Electrical Adjustments Service adjustments to this model can be performed using the supplied remote commander RM-ED009. How to enter into the Service Mode Turn on the power to the TV set and enter into the stand-by mode.
RM-ED009 3-2. TT MODE TT mode is available by setting the TV for operation in Service Mode [ As shown on Page 14 ] , OSD ‘TT’ appears. The functions described below are available by selecting the two numbers. To release the ‘Test mode 2’, press 00, 10, 20 ... twice or switch the TV set into Stand-by mode.
RM-ED009 3-3. TT OSD Labels T T - " E C S C B A N o r m (20) D D C (21) (10) (11) (12) (22) (13) (14) (15) (16) (17) (18) (19) (23) (24) Key: Panel size configuration. Changed by TT61...TT68. D/A: D is shown when Digital mode is enabled;...
NJM3414 L/R IN HP AMP CVBS_1 L/R PC CVBS_2 L/R OUT L/R OUT DIG: HYBRID L/R IN L/R IN TDA8933 PHILIPS / SONY POWER SUPPLY SPK AMP COMPONENT SPEAKERS GS1 (20"), GS2 (26"), GS5 (23") B1 BOARD - 18 -...
Page 31
B1.-SE2 MOUNT ALL THESE CONNECTORS IN THE "FE" AREA 3.3V_MAIN 3.3V_MAIN *** MOUNT *** I2C_TV D7500 D7502 C7501 R7505 R7510 JL7501 FIT FOR R7500 JTAG CN7500 SCL_EMMA Q7500 +3V3D R7501 TP7500 SIGN15457 SDA_EMMA Q7502 JL7503 FE_TXD0B TXD0B_MAIN AVC/EMMA COMMS JL7504 FE_RXD0B RXD0B_MAIN JL7505...
SECTION 5 EXPLODED VIEWS NOTE : Non-serviceable items with no part number and no Items marked “*” are not stocked description are not stocked because they are not since they are seldom required for required for routine service. routine service. Some delay should be anticipated when ordering these The construction parts of an assembled part are indicated with a collation number in the remarks column.
5-2. CHASSIS (26 inches) SECTION 5 EXPLODED VIEWS NOTE : Non-serviceable items with no part number and no Items marked “*” are not stocked description are not stocked because they are not since they are seldom required for required for routine service. routine service.
....................71 Note: To ensure safety and reliability it is Sony policy that power supply boards should not be repaired at component level in the field as a result... The GS1, GS2 and GS5 boards are regarded as non service...
Page 58
Note : The components identified by mark contain confidential information. Strictly follow the instructions when ever the components are repaired and/or replaced. REF.NO. PART.NO DESCRIPTION REMARK REF.NO. PART.NO DESCRIPTION REMARK * A-1334-484-A B1 COMPLETE (KDL-20B40xx) C2212 1-126-395-11 ELECT CHIP 22UF 20.00% 16V * A-1517-426-A B1 COMPLETE (KDL-23B40xx) C2213...
Page 75
REF.NO. PART.NO DESCRIPTION REMARK REF.NO. PART.NO DESCRIPTION REMARK X4000 1-813-531-11 OSCILLATOR, CRYSTAL UNIT R5586 NOT FITTED X5500 1-813-806-21 OSCILLATOR, CRYSTAL R5587 NOT FITTED X7200 1-813-055-11 QUARTZ CRYSTAL UNIT R5588 NOT FITTED X7201 1-813-784-21 VIBRATOR, CRYSTAL R5589 NOT FITTED R5590 NOT FITTED Variant Parts List (KDL-20B40xx) R5591 NOT FITTED...