Table of Contents
Advertisement
Menu functions:
Navigate the main menu with the UP / DOWN buttons.
Main screen part 1
Temperature T1 ° C
Humidity in RH
Temepratur T2 in C °
Time
Main screen part 2
Fanspeed 1
Fanspeed 2
Main screen part 3
Alarms of the exceeded maximum values.
T1
= Temperature sensor 1 max.
RH
= Humidity sensor 1 max.
T2
= Temperature sensor 2 max.
Alarms of underrun minimum values.
T1
= Temperature sensor 1 min.
RH
= Humidity sensor 1 min.
T1
= Temperature sensor 2 min.
Confirm with the SAVE / EXIT button an alarm. The 9. alarm LED will switch off should the
actual value be below the set value. Depending on the model there is located a dry contact
in the inside the 16A controller. This contact is closed on alarm.
Main menu:
Go with the ENTER button one level deeper into the menu. Here is a selection of the four
main menu items.
1. Set fan settings = Ventilator settings
2. Set exit 1 = Output setting of exit 1
3. Set exit 2 = Output setting of exit 2
4. General settings = General Settings
Mainscreen 1
T1=23.4C° RH=60%
T2=19.1C°
Fanspeed 1
Fanspeed 2
T1--- T2--- H---
T1--- T2--- H---
Shows the measured in ambient air temperature.
Shows the measured in the room relative humidity.
Displays measured in the water temperature.
Displays the current time in hours and minutes.
shows in% the fan speed of the exhaust air fan.
shows in% the fan speed from the supply air fan.
09:13
90%
70%
page 7 of 15
Advertisement
Table of Contents
