Settings Of Switched Outputs Exit2; Submenu General Settings; Time And Date Settings - G-Systems 16A User Manual

Press ENTER button, the first two character of the switch on time starts to blink. Now you
select the hours for the on-time. Change the value with UP / DOWN buttons and confirm
with ENTER. Now the next two minutes-character of the on time starts to blink. Repeat the
process, and confirm with ENTER. Now blinks the hours of the off time, repeat the process
and set the minutes and seconds of the off time. Save the first program step with SAVE /
EXIT. With the DOWN button to enter the next programming step, it shows on the display
Exit 1 timer 02 for the second programming step. Repeat everything again until you reach
the next programming step Exit 1 timer 03. When you are finished, press the SAVE / EXIT
button to save and return to reach the selection menu "Set Exit 1"
To delete a program step, set the time back to 00:00
When you have finished programming the "Exit 1" press SAVE / EXIT to return to the main
menu.

Settings of switched outputs EXIT2:

Select "Output 2" and repeat the same procedure as described for "Output 1"

Submenu general settings:

Navigate in the main menu to "General settings.", press ENTER to get the selection.
Select one of the following settings that you want to change.
Here can be made all the general settings for the 16A fan controller:
Set date / time
Set language
Set photosensor
Set display
Set alarm
Set log file
Res. factory set
Set time
Set language
Set photosensor
Set display
Set alarm
Set log file
Res. factory set

= Time and date settings

= Language settings
= Light sensor settings
= LCD Display settings
= Alarm settings
= Recording of historical data (Only for model with USB recording)
= Reset to factory settings
00:00:00.
page 12 of 15