Installation; Positioning And Levelling; Connecting The Water And Electricity Supplies - Hotpoint Ariston ELTB 6M124 Manual

Installation

If the appliance must be moved at any time, keep it in an
upright position; if absolutely necessary, it may be tilted onto its
back.

Positioning and levelling

it has not been damaged during transportation. If it has been
damaged, contact the retailer and do not proceed any further
with the installation process.
contact with the adjacent cabinets or the wall. This appliance
can also be recessed under a single worktop
Instruction sheet.)
3. Position the dishwasher on a level sturdy floor. If the floor
is uneven, the front feet of the appliance should be adjusted
correctly, it will be more stable and much less likely to move or
cause vibrations and noise while it is operating.
*
4 . To adjust the height of the rear foot, turn the red hexagonal
bushing on the lower central part at the front of the dishwasher
using a hexagonal spanner with an opening of 8 mm. Turn the
spanner in a clockwise direction to increase the height and in an
anticlockwise direction to decrease it
sheet attached to the documentation.)

Connecting the water and electricity supplies

Connection to the water and electricity supplies should only
The dishwasher should not stand on the water hoses or
electricity supply cable.
The appliance must be connected to the water supply
network using new hoses.
Do not use old piping.
The water inlet and outlet hoses and the electricity supply cable
may be positioned towards the right or the left in order to achieve
the best possible installation.
Connecting the water inlet hose
the hose, run the water until it is perfectly clear so that any
impurities that may be present in the water do not clog the
appliance; after performing this operation, screw the inlet
hose tightly onto a tap with a ¾ gas threaded connection.
may be supplied with hot water from the mains supply (if you
have a central heating system with radiators) provided that it
Screw the hose to the tap as described for connection to a
cold water supply.
If the inlet hose is not long enough, contact a specialist store
(see Assistance.)
or an authorised technician
The water pressure must be within the values indicated in
(see adjacent information.)
the Technical Data table
The hose should not be bent or compressed.
*
(see the Assembly
(see Building-in Instruction
Connecting the water outlet hose
Connect the outlet hose (without bending it) to a drain duct with
a minimum diameter of 4 cm.
Before connecting the water outlet hose to the sink drain, remove
the plastic plug (B).
Anti-flooding protection
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
*
device New Acqua Stop , which guarantees anti-flooding
protection even in the event of a supply hose rupture.
WARNING: HAZARDOUS VOLTAGE!
Under no circumstances should the water inlet hose be cut, as
it contains live electrical parts.
Electrical connection
Before inserting the plug into the electrical socket, make sure
that:
which is indicated on the data plate located on the inside of
the door
(see Description of the appliance);
the data plate on the inside of the door.
this is not the case, ask an authorised technician to replace
the plug ( see Assistance ); do not use extension cables or
multiple sockets.
Once the appliance has been installed, the power supply
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced
by the manufacturer or its Technical Assistance Service in order
*
Only available in selected models.
(see Assistance.)
EN
17