Deactivating Configured Interfaces; Removing, Installing, And Replacing Nics - Nokia EM7500 Installation Manual

4
Installing and Replacing Network Interface Cards
Caution
Protect your appliance and other electronic equipment from
electrostatic discharge (ESD) by making sure you are properly
grounded before touching any electronic components.

Deactivating Configured Interfaces

If you are removing or replacing an installed NIC, use Network Voyager to
deactivate any configured ports on the NIC before removing it.
Deactivate all of the logical interfaces on the NIC.
Deactivate all of the physical interfaces on the NIC.
If you do not deactivate the interfaces before removing the NIC, you may
have to reinstall the NIC to deactivate its logical and physical interfaces in
Network Voyager.
For information about how to access Network Voyager, see
Network Voyager"

Removing, Installing, and Replacing NICs

Note
Before removing a configured NIC with these instructions, you must
deactivate the NIC in Network Voyager. For additional information, see
"Deactivating Configured Interfaces"
Use these instructions to remove, install, or replace a NIC in the IP390
appliance. Some steps are not applicable to all procedures. The instructions
point out steps appropriate to each procedure.
52
All manuals and user guides at all-guides.com
on page 45.
on page 52.
IP390, 105i & 105s Security Platform Installation Guide
"Using Nokia