Switching On And Off; Setting The Date And Time - FujiFilm 1400 Owner's Manual

SWITCHING ON AND OFF

1
To switch the camera on, move the Mode switch
E D
from OFF to " " or " ". When you switch the
camera on, the green viewfinder lamp lights.
To switch the camera off, set the Mode switch to
OFF. If the date and time settings have been
cleared, a confirmation screen appears. To set
the date and time, use the " or button to
d c"
select "SET" and then press the "MENU/EXE"
button ( P.18).
!
If the "H" message appears on the LCD
16
monitor, open the lens cover ( P.19).
2
Blank
Flashing
On
With the LCD monitor on, you can check the
remaining charge in the battery.
Battery has ample charge.(No indicator
displayed.)
Battery charge low. Replace or recharge the
battery as it will run out shortly.
The battery is exhausted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the battery.
Auto Power Off Function
If the camera is left switched on for two minutes or
more, the Auto Power Off function automatically
switches the camera off. To switch the camera back
on, set the Mode switch to OFF and then set it back to
E D
" " to take pictures or " " to view images. Holding
down the "MENU/EXE" button as you switch the
camera on disables the Auto Power Off function.
!
If the date and time shown on the LCD monitor
blinks, set them (next page)
!
If the battery charge is depleted, you may not be
able to switch the LCD monitor on.

SETTING THE DATE AND TIME

1
If the date and time settings are cleared when
you switch the camera on, a confirmation screen
appears. If you chose to reset the date and time,
proceed from step 3 .
Check that the lens cover is open ( P.19) and
E
then set the Mode switch to " ".
When you press the "MENU/EXE" button.
the menu screen appears.
Use the " " and " " buttons to select MODE and
d c
then use the " " button to select "SET-UP".
ab
press the "MENU/EXE" button.
2
Use the " " button to select "DATE/ TIME",
ab
and
press the "MENU/EXE" button.
!
If you take the batteries out of the camera for 5
minutes or more, or remove the batteries during
setup, the camera settings may all revert to the
factory default values.
!
See P.63 for more information on the SET-UP menu.
1
17