Power Trim And Tilt Switches; Trim Tab With Anode - Yamaha F250B Owner's Manual

Components
the risk of falling overboard and could dis-
tract the operator, increasing the risk of
collision with another boat or an obstacle.
EMU35851

Power trim and tilt switches

The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
board motor up, and then tilts it up. Pressing
the switch " " (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
UP
1
DN
1
1. Power trim and tilt switch
38
" (up) trims the out-
UP
ZMU05835
DN
UP
1
DN
1. Power trim and tilt switch
On the twin engine control, the switch on the
control grip controls both outboard motors at
the same time.
On the triple engine control, the switch on the
control grip controls all outboard motors at the
same time.
For instructions on using the power trim and
tilt switches, see pages 75 and 78.
EMU26244

Trim tab with anode

EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
1
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A" in
the figure. If the boat tends to veer to the right
(starboard side), turn the trim tab end to the
starboard side "B" in the figure.
UP
ZMU05964
DN
1