Setting The Alarms - Sharper Image WS0832 User Manual

Press ALARM key again to view the LOW alarms along with the alarm clock time the
same way HI alarms.
Press the SNOOZE key at any time to return to the normal mode.
8.3 Setting the Alarms
Press ALARM key to enter the alarm mode.
Press and hold the SET key for three seconds. The first alarm parameter will begin flashing
(alarm hour).
To save the alarm setting and proceed to the next alarm parameter, Press (do not hold) the
SET key.
To adjust the alarm parameter, press the [+] or [-] key to increase or decrease the alarm
settings, or press and hold the [+] or [-] key for three seconds to increase or decrease the
alarm settings rapidly.
Press the ALARM key to turn on (the alarm icon will appear ) and off the alarm.
Press the SNOOZE key once at any time to return to the normal mode. After 30 seconds of
inactivity, the alarm mode will time out and return to normal mode.
The following is a list of the individual alarm parameters that are set (in order):
1. Alarm hour
2. Alarm minute
3. Outdoor temperature high alarm
4. Outdoor temperature low alarm
5. Outdoor humidity high alarm
6. Outdoor humidity low alarm
7. Outdoor AT high alarm
8. Outdoor AT low alarm
9. Outdoor dew point high alarm
10. Outdoor dew point low alarm
11. Outdoor feels like high alarm
12. Outdoor feels like low alarm
13. Wind Gust high alarm
14. Wind Average high alarm
15. Rainfall (RATE) high alarm
16. Rainfall (24h) high alarm
17. Indoor temperature high alarm
18. Indoor temperature low alarm
19. Indoor humidity high alarm
20. Indoor humidity low alarm
Note: To prevent repetitive temperature alarming, there is a 0.5 °C tolerance band. For
example, if you set the high alarm to 26.7 °C and silence the alarm, the alarm icon will
continue to flash until the temperature falls below 26.2°C, at which point, the alarm will
reset and must increase above 26.7 °C to activate again.
18