Visit the Frigidaire Web Site at: http://www.frigidaire.com Range Welcome... 2 ES300 Control, Self-Cleaning Oven with Sealed Gas Burners Important Safety Instructions ...3-4 Features at a Glance ... 5 Before Setting Oven Controls ...5-6 Setting Surface Controls ... 6 Oven Control Functions ... 7 Setting Oven Controls ...
DO NOT cut or remove the grounding prong from this plug. For personal safety, the range must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded.
Ask your dealer to recommend a qualified technician and an authorized repair service. Know how to disconnect the power to the range at the circuit breaker or fuse box in case of an emergency. • User servicing—Do not repair or replace any part of the appliance unless specifically recommended in the manuals.
• Do Not Heat Unopened Food Containers—Buildup of pressure may cause container to burst and result in injury. • Remove the oven door from any unused range if it is to be stored or discarded. IMPORTANT—ELECTRIC IGNITION MODELS ONLY: Do not attempt to operate the oven during a power failure.
Fig. 1 Oven Racks Your range is equipped with one or more Flat Oven Rack(s). Place the rack(s) into the positions shown in Fig. 2. Refer to the following Recommended Rack Positions for Broiling, Baking & Roasting for complete information.
Setting Surface Controls Your range may be equipped with different sized surface burners. The SIMMER burner (some models) is best used for simmering delicate sauces, etc. The standard burners can be used for most surface cooking needs.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad functions of the oven as described below. BAKE TIME PAD— Used to enter the length of the baking time. CLOCK PAD— Used to set the time of day.
To Set the Clock When the range is first plugged in or when the power supply to the appliance has been interrupted, the display will flash "12:00". 1. Press once (do not hold pad down). 2. Within 5 seconds press & hold the correct time of day appears in the display.
To Set Timed Bake with Delay Start BAKE TIME and Place the food in the oven.3. Press Be sure that the clock shows the correct time of day. o u . o u o or pad until the desired baking timeappears in the display.7. The oven will turn ON & begin heating.To Program Oven for a Delayed Start Time & to Shut-Off Automatically (Delayed Timed Bake): "...
Setting Oven Controls (cont’d) For Roasting: 1. Preheating is not necessary when roasting foods with Speed Bake™ Cooking System. 2. Since Speed Bake cooks food faster, reduce the cook time by 25% from the recommended cook time of your recipe. Increase the time until the desired doneness is obtained.
During the Self-Cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave small children unattended near the appliance. The health of some birds is extremely sensitive to the fumes given off during the Self-Cleaning cycle of any range.
4. Replace glass shield over bulb and snap wire holder into place. 5. Turn power back on again at the main source (or plug the range back in). 6. The clock will then need to be reset. To reset, see Setting the Clock &...
General Care & Cleaning (cont’d) Cleaning the Contoured Well Areas, Burner Cap, Burner Head & Burner Drip Pans The contoured well areas, burner cap, burner head and burner drip pans (some models) should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions: THE COOKTOP IS NOT REMOVABLE.
Range is not level - (1) Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the oven rack is level. (2) Be sure floor is level, strong & stable enough to adequately support range.
Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.