Brodit 511627 Quick Start Manual

25 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 511627
511627 Passive holder with tilt swivel Adjustable holder. Fits devices with skin. Width: 226-309 mm. Height:
151-226 mm.
With your surfpad in a holder attached in your car you will always have it within easy reach. Safe, neat and
convenient! You can connect e.g. a charging cable to the surfpad when it is in the holder. The holder is mounted
onto a tilt swivel so you can adjust the angle and switch between portrait and landscape mode.
Features
The adjustable holder fits for devices with the following dimensions: Width: 226-309 mm, Height: 151-226 mm.
Measure your device and compare with the holder specifications in order to make sure you have chosen the
correct product. Before using the holder you set the size to fit with your device. The holder is designed with the
intention to leave as much space open as possible for connection of charging cables and/or headphones.
Important
Tablets should not be installed onto a car's dashboard if they block the view or block key controls. The ProClip is
designed for installation of smaller devices (phones), not for large devices (tablets). If you want to place a tablet
onto the car's dashboard, each combination of tablet-car must be examined in detail by you in order to determine
if such an installation is possible in the specific case. Consideration should be given to the position and how firmly
the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations
for such installations.
An installation of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit
recommends to use tablets on the car's headrest, installed onto a Brodit headrest mount.
EAN: 7320285116276