Friedrich MR09C1H Installation And Operation Manual page 12

Remote Control Instructions
8
TIMER ON :
Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply
press this button again.
After pressing this button,
setting. Within 5 seconds, press + or - button to adjust the time value. Every press of either
button changes the time setting by 1 minute. Holding down either button rapidly changes the
time setting by 1 minute and then 10 minutes. Within 5 seconds after setting, press TIMER
ON button to confirm.
9 AIR SWEEP:
Press this button to set up & down swing angle, which circularly changes as below:
This remote controller is universal. If any command
the unit will carry out the command as
indicates the guide louver swings as:
10
EXTEND:
Pressing
EXTEND
fan will continue operation for 10 min utes in order to dry the indoor unit even though you
have turned off the unit.
After energization,
HEAT mode.
11
TEMP:
By pressing this button you can display
temperature.When the indoor unit
if the temperature's display status is changed from other status to"
ambient temperature, 5s later or within 5s, it receives other remote control signal that will
return to display the setting temperature. if the users haven't set up the temperature
displaying status,that will display the setting temperature.(This function is not applicable
for some models).
12
TIMER OFF :
Press this button to initiate the auto-off timer. To cancel the auto-timer program, simply
press the button again.TIMER OFF setting is the same as TIMER ON.
TURBO:
13
Press this button to activate / deactivate the Turbo function which enables the unit to
reach the preset temperature in the shortest time. In COOL mode, the unit will blow strong
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed. (This function is not applicable for some models).
disappears and "ON "blinks . 00:00 is displayed for ON time
OFF
button in COOL or DRY mode, the icon
OFF is defaulted.
EXTEND
is first powered on
,
is not available in AUTO, FAN or
EXTEND
the indoor setting temperature or indoor ambient
it will display the setting temperature,
8
or is sent out,
is displayed and the indoor
",displays the