Error Tone Output Setting [Error Tone]; Error Tone Output Setting - Fostex PD606 Owner's Manual

The "Error tone" menu item selects whether generating the error tone (warning tone) or not for
each of four kinds of troubles (see below) independently.
1. A write error happens during recording. [Write error]
2. The peak indicator lights due to input overload during analog recording or clipping of the stereo
buss. [Input clip]
3. The battery voltage drops below the threshold voltage set by the "BATT. warning" menu item. [BATT
warning]
4. The remaining recording time of a disk (or a partition) gets under the specified time. [Disk warning]
1) While the unit is stopped, press the [SHIFT] key to light the SHIFT indicator, followed by the
[ENTER/YES] key.
2) While "SYS SETUP" is highlighted, press the [ENTER/YES] key.
The display now shows the SYS SETUP menu screen.
3) Use the [MENU] dial to select the "Error tone" menu item and press the [ENTER/YES] key.
You can select "On" or "Off" of the error tone for "Write error", "Input clip" and "BATT
warning", as well as can set the time for "Disk warning".
• Write error On or Off setting
Use the [MENU] dial to select the "Write error" and press the [ENTER/YES] key.
The current setting starts flashing and you can now select the desired option.
Use the [MENU] dial to select the desired option and press the [ENTER/YES] key to
confirm your setting.
If a write error occurs while you set "Write error" to "On",
the warning tone is output by the pattern on the right.

Error tone output setting [Error tone]

You can select between "On" and "Off" (the default is "On").
Chapter 8: MENU mode/SYS SETUP menu
Options
Location Recorder Model PD606
Flashing
165