Key Functions In The Parameter【Mode A And B; How To Access The【Mode Value】 And Adjust The Setting - Siruba C007KD Manual

(4). Key functions in the Parameter【Mode A and B】 ：(Example as the following)
Enter Value area
Same as parameter
increment key
Parameter
increment key
Parameter
decrement key
In 【Mode A】 First parameter showing is 【001. H】 All available parameter start 1~46.
7-segment
display
In 【Mode B】 First parameter showing is 【047.MAC】 All available parameter start 1~122.
(5). How to access the【Mode Value】 and adjust the setting
Step 1：Confirm the parameter code you want to make adjust.
(See the parameter table for the detail)
Step 2：Follow the instruction to access parameter area and call out the parameter code make range.
Speed, timing and angle setting can be set as the following：
Step 3：Start making adjust parameter value. (Function selection use key
value setting for your reference)
A). How to increase the default value：
Example Factory default setting【H.4500】increase to【H.5000】. (See chapter 5, section (4) or (5)
to learn how to access a、b、c value setting, then do the following step by step.)
d. Into 【H.4500】value area.
.
S
g. Press
value.
B). How to decrease the default value：
Example：Factory default setting【H. 4500】decrease to【H. 4000】 ：
key to save the
.
e. Press just 1000
th
100 digit.
.
(Note: Use
value to 5, and
h. Go back to【Normal Mode】.
.
9
7-segment display
No function
No function
and
STOP
th f. After it shown at 5000.
and
key to
adjust
key
to 0)
to【001. H】
.