LaserLiner MasterCross-Laser 2P Operating Instructions Manual page 9

1
1 Laser emitting window
2 Slide switch
a ON
b Slope mode
c OFF / Transport lock
3 Battery compartment
(bottom)
Horizontal and vertical levelling
2
Release the transport restraint, set slide switch (2) to "ON". The laser cross and the two plumb lasers
appear. The laser lines can be switched individually with the selection button.
LASER LASER
The transport restraint must be released for horizontal and vertical levelling. The laser lines
!
and the plumb lasers flash when the device is outside the automatic levelling range of 3°.
Position the device such that it is within the levelling range. The light of the laser lines and
plumb lasers is constant.
a b c
3
4
5
10
4 5/8" tripod threads
(bottom)
5 1/4" tripod threads
(bottom)
6
Hand receiver mode
7 LED Hand receiver mode
LASER LASER
MasterCross-Laser 2P
10
7
6
2
When transporting always
!
switch off all lasers, secure
the pendulum and set the
slide switch to "OFF"!
8 LED Status indicator
9 Laser line selection button
10 Laser emitting window,
plumb laser
LASER
8
9
09
GB