Husqvarna R 214 2021 Workshop Manual page 42

Transmission
Belt 1
belt
Belt 2 Main belt
Belt 3 Equipment belt
9.9.2 To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt cover and
remove the cover.
2. Lubricate with a grease gun through the grease
nipple at the right side, below the lower belt pulley.
Lubricate until grease comes out of the rear side of
the grease nipple.
3. Attach the belt cover and tighten the 2 screws.
9.9.3 To remove the transmission belt
1. Lift up the cutting deck.
2. Remove the transmission cover. Refer to
the transmission cover on page 18 .
42 - Repair instructions
3. Remove the snap ring and remove the cooling fan.
Engine pulley to
transmission pul-
ley
Engine pulley to
intermediate pul-
ley
Intermediate pul-
ley to cutting
deck
4. Disengage the spring on the belt tensioner.
5. Remove the transmission belt from the hydrostatic
6. Remove the engine pulley covers on the left and
To remove
transmission pulley with a screwdriver and a wrench.
right side of the product.
1592 - 003 - 05.01.2022