Husqvarna R 214 2021 Workshop Manual page 19

9.1.1.7 To remove the frame tunnel cover
1. Remove the 2 screws (A).
2. Push the frame tunnel cover rearward (B) and lift the
front end of the frame tunnel cover (C).
9.1.2 Throttle cable
9.1.2.1 To do a check of the throttle cable
Make sure that the engine speed changes when the
throttle is changed. Do a check that the engine gets the
correct speed at full throttle. See
49
9.1.2.2 To adjust the throttle cable
Note: The throttle cable looks different on different
engine models.
1. Loosen the clamp screw for the cable casing on the
throttle cable and move the throttle control to the full
throttle position.
2. Make sure that the throttle cable is attached to the
correct hole.
3. Pull the cable casing on the throttle cable away from
the hole and tighten the clamp screw.
1592 - 003 - 05.01.2022
C A
B
Technical data on page
9.1.3 Seat
9.1.3.1 To adjust the seat
The seat can be tilted forward. It can also be adjusted
forward and rearward. Loosen the handles below the
seat to adjust it forward or rearward.
9.1.4 Parking brake
9.1.4.1 To examine the parking brake
WARNING: The brake effect can decrease if the
parking brake is not correctly adjusted.
1. Park the product on a slope with a hard surface.
WARNING: Do not park the product on a
grass slope when you do a check of the
parking brake.
2. Push the parking brake pedal (A) down.
3. Push and hold the lock button (B).
4. Release the parking brake pedal while you push the
lock button (B).
5. If the product moves, adjust the parking brake.
B
A
Repair instructions - 19