Husqvarna R 214 2021 Workshop Manual page 33

10. Fill the transmission oil tank until the oil is at the
maximum level. The product must be level and the
oil must have a temperature of approximately 20 °C.
11. Bleed the hydraulic system. Refer to
oil in the 2WD transmission on page 35 .
12. Start the product and do a check for an oil leak from
the new shaft seals.
13. Do a check of the oil level and if it is necessary, fill
the transmission oil tank after the test run.
9.5.5 Hydrostatic transmission cable
9.5.5.1 To remove the hydrostatic transmission cable
1. Remove the frame tunnel cover. Refer to
the covers on page 18 .
2. Loosen the cable locknut for the front hydrostatic
transmission ¼ turn.
3. Loosen the locking spring (A) and remove the
locking spring (B).
4. Remove the cable clamp for the front hydrostatic
transmission. The cable clamp is attached below the
frame tunnel cover.
5. Remove the transmission cover. Refer to
the covers on page 18 .
1592 - 003 - 05.01.2022
Max
Min
To replace the
To remove
A
B
To remove
6. Remove the locking spring and the ball joint on the
rear hydrostatic transmission cable from the arm.
Remove the rear clamp.
7. Lift the front ball joint and pull out the cable.
8. Lift out the hydrostatic transmission cable and the
ball joint.
9. Loosen the 2 ball joints from the hydrostatic
transmission cable.
10. Pull out the hydrostatic transmission cable.
9.5.5.2 To assemble the hydrostatic transmission cable
1. Attach the front link joint onto the new hydrostatic
transmission cable (A) and tighten the locknut (B).
A
2. Push the new cable through the frame in the same
routing as the used cable.
3. Push the cable sheath into the front bracket below
the frame tunnel cover.
B
Repair instructions - 33