Husqvarna R 214 2021 Workshop Manual page 20

9.1.4.2 To adjust the parking brake
1. Loosen the parking brake locknuts (A) on the
adjustment screw (B).
2. Hold the adjustment screw (B) and turn the locknuts
(A) until the cable is tight.
3. Tighten the parking brake locknuts (A).
4. Examine the parking brake after the adjustment.
To examine the parking brake on page 19 .
Refer to
9.1.5 Wheel hub
9.1.5.1 To remove and install the wheels
CAUTION: The dimension of the spacers and
the number of washers can change between
different wheels. Do not mix parts from different
wheels.
1. Put supports below the product. Refer to
supports below the product on page 6 .
2. Remove the protective cap.
3. Remove the snap ring.
4. Pull off the wheel from the axle.
5. Collect the spacer sleeve and washers from the
axle.
6. Install in opposite sequence.
20 - Repair instructions
A
B
To put
9.1.6 Rear axle
9.1.6.1 To disassemble the pivoting rear axle
1. Put supports below the product in front of the
articulated steering.
2. Remove the rear wheels. Refer to
install the wheels on page 20 .
3. Loosen the locknuts (A) of the steering cables.
4. Hold the cable with a wrench and remove the
adjuster nuts (B).
5. Remove the idler spring.
To remove and
B
A
1592 - 003 - 05.01.2022