Husqvarna R 214 2021 Workshop Manual page 37

5. To make sure that no weight is applied on the
support wheels, put a wooden block between the
frame and the bathroom scale.
6. To adjust the ground pressure, turn the adjustment
screws found behind the front wheels on the right
and left sides.
7. Turn the screws right or left until the ground
pressure is between 12 and 15 kg (26.5-33 lb).
9.6.4 To adjust the parallelism of the cutting deck
1. Remove the front cover. Refer to
front cover on page 18 .
2. Loosen the locknuts on the lifting rod.
1592 - 003 - 05.01.2022
3. Turn the adjustment nut to extend the lifting rod or
4. Tighten the locknuts on the lifting rod when the
5. Do a check of the parallelism. Refer to
6. Install the front cover.
To remove the
9.6.5 To adjust the cutting height
1. Make sure that the cutting height stay is attached to
2. Put the cutting height lever in the lowest cutting
3. Remove the right footrest plate and the right side
4. Turn the adjustment nut until there is no play
5. Do a check of the parallelism of the cutting deck.
6. Do a check of the ground pressure of the cutting
make it shorter. Extend the lifting rod to lift the rear
edge of the cover. Make the lifting rod shorter to
lower the rear edge of the cover.
adjustment is done.
check of the parallelism of the cutting deck on page
11 .
the cutting deck.
height position.
cover. Refer to To remove the covers on page 18 .
between the cutting deck and the cutting height stay.
To do a check of the parallelism of the
Refer to
cutting deck on page 11 . Adjust the parallelism if it is
To adjust the parallelism of the
necessary. Refer to
cutting deck on page 37 .
To examine and adjust the ground
deck. Refer to
pressure from the cutting deck on page 36 .
To do a
Repair instructions - 37