13. Fusing separation pawl disassembly
1
Remove the document table and the top cabinet.
2
Remove the fan unit and the main PWB.
3
Remove the fusing separation pawls.
14. Upper heat roller disassembly
1
Remove the document table and the top cabinet.
2
Remove the fan unit and the main PWB.
3
Remove the fusing separation pawl.
4
Remove the heater lamp.
5
Remove the main chassis.
6
Remove the rings and gears in the both sides of the bearing, and
remove the bearing.
Upper heat roller
Ring
Bearing
Gear
Fusing separation pawl
Note: Be careful not to scratch the roller.
Note for assembly: Be sure to insert the ring securely in the heat
roller groove.
15. Paper feed unit and resist roller
removal (Z-26)
1
Remove the document table and the top cabinet.
2
Remove the main chassis.
3
Remove the arm A.
Arm A
4
Remove the two screws and an E-ring which are fixing the paper
feed unit.
5
Forcibly pull the resist roller upwards to remove.
6
Remove the paper feed unit.
Note for assembly
•
Hang the release lever spring attached to the resist roller shaft on
the resist lever and put the spring end in the groove.
•
Attach the drive belt securely.
•
Be careful to the solenoid plunger position.
– 21 –