INK+IVY MEL-802 Assembly Instructions

Table of Contents

Download this manual

Important safety instructions:

Please carefully read all instructions before assembling the chair.

For your safety and ease, assembly by two or more adults is recommended.

Keep instructions for future use.

Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or

hardware.

Remove all parts and hardware from box along with any plastic protective packaging.

Bolts Ø1/4*3"

Bolts Ø1/4*2"

Lock Washers

Big Flat Washers Ø1/4" *19mm

Small Flat Washers Ø1/4" *12mm

Allen Wrench 1/4"

Wooden Plugs

Ø1/4"

Table of Contents

Do you have a question about the MEL-802 and is the answer not in the manual?

Page 1 Important safety instructions: Please carefully read all instructions before assembling the chair. For your safety and ease, assembly by two or more adults is recommended. Keep instructions for future use. Pre-assembly: Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
Page 2 Assembly Procedures: Step 1. Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching the finish. Attach seat cushion (A) and back frame (B) to the left leg (C) according to the label " L" on the left leg. Securely tighten all bolts with Allen wrench ( f) .
Page 3 Step 3. Loosely attach right leg (D) to the seat cushion (A), back frame (B ) and stretchers 2 (F) according to the label "R" on the right leg as show below. Securely tighten all bolts with Allen wrench ( f) . ( a)x2 Bolts ( b)x4...
Page 4 Step 5. 1) Turn the assembled chair to an upright position. Securely tighten all the bolts with Allen wrench (f). 2) Attach wooden plugs ( g) to each bolt hole, tighten with rubber hammer to knock the wooden plug till its tighten. Note: use a soft cloth between the wooden plug and hammer to prevent damage to wooden plug finish.