INK+IVY Kelly Assembly Instructions

Lounge chair

Important safety instructions:

Please read carefully all instructions before assembly.

For your safety and ease, assembly by two or more adults is recommended.

Keep instructions for future use.

Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.

Take out all parts and hardware from box.

DISCLAIMER:

WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES

RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.

Step 1. Assemble the lounge on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.

Attach seat cushion (P1) with one located dowel to left arm (P3), please note the label "P3" on the left arm (P3) as

shown below. Loosely tighten the bolts with Allen wrench (H7).

Table of Contents

Do you have a question about the Kelly and is the answer not in the manual?

Page 1 Important safety instructions: Please read carefully all instructions before assembly. For your safety and ease, assembly by two or more adults is recommended. Keep instructions for future use. Pre-assembly: Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware. Take out all parts and hardware from box.
Page 2 Step 3. Loosely attach right arm (P4) with label "P4" to seat cushion (P1). Loosely tighten by Allen wrench (H7) as shown below.
Page 3 Step 5. 1) Make sure the assembled lounge is level and s ecurely tighten all the bolts with Allen wrench (H7). 2) Attach wooden plugs ( H6) to each exposed bolt holes, tighten with rubber hammer to knock the wooden plug till its tighten.