Heating Mode - Saunier Duval IsoTwin Condens T 26-CS/1 Instruction Manual

Machine Translated by Google
The other hot water mode settings
health are covered in the chapters
correspondents.
When the basic display appears, ap
press In
the presence of a fault, the display of
base gives way to a fault message.
4.1.2 Command levels
When the basic display appears, go to the
menu to access the
user command level.
The level reserved for the installer (access
technician) requires knowledge
very specific. This is why it is protected by
an access code.

4.2 Heating mode

In heating mode, the rooms are heated
according to your settings.
4.2.1 Setting the temperature of
start of heating
Condition: No controller connected and mode
scheduled heating is disabled
ÿ From the "basic display", ap
press once on to display the
flashing symbol.
ÿ The set heating flow temperature appears on
the display.
ÿ Press to set the
heating flow temperature which
agrees.
ÿ Confirm with .
ÿ The set temperature flashes 2 times
quickly.
Condition: No controller connected and mode
programmed heating is activated
ÿ Deactivate the scheduled heating mode (ÿ
page 9).
8
to access the menu:
Where
ÿ From the "basic display", ap
press once on to display the
flashing symbol.
ÿ The set heating flow temperature
appears on the display.
ÿ Press the
heating flow temperature which
agrees.
ÿ Confirm with .
ÿ The set temperature flashes 2 times
quickly.
ÿ Activate scheduled heating mode
(ÿ page 9).
Condition: Controller connected
ÿ From the "basic display", ap
press once on to display the
flashing symbol.
ÿ on or oFF appears on the screen.
– indicates that the heating mode
is activated.
– oFF indicates that the heating
mode is deactivated.
ÿ If the display shows oFF, then press
on the key
heater.
ÿ Confirm with .
ÿ one flashes 2 times quickly.
ÿ Set the flow temperature of the
heating that suits the level of the
regulator (ÿ operating manual for the
regulator).
4.2.2 Adjusting the settings of the
heating ranges
1. Press
2. Press to adjust the
heating flow temperature
on the ranges and validate with .
3. Press to view the heating flow temperature
outside the ranges.
Instructions for use IsoTwin Condens 0020294193_00
to adjust the
Where
to activate the mode
.
and