Replacing The Filter - Fantom FM741 Instruction Manual

REPLACEMENT INSTRUCTIONS

REPLACING THE FILTER

Under normal usage, the HEPA Filter will not require replacement;
however, vacuuming large amounts of extremely fine dust, powder or similar
material over a long period of time may decrease airflow performance through
the filter. If this occurs, it may become necessary to replace the HEPA
Filter. Only use genuine FANTOM replacement filters.
Press the release button D at points
1
and pull the filter cover away from the
vacuum cleaner.
Remove the HEPAfilter.
2
Caution:
Do not attempt to wash the HEPAfilter.
Always replace the old filter with a new one.
Insert a new HEPAfilter with the seal
3
to the inside of the vacuum cleaner.
Reattach the filter cover.
Caution:
Be sure that seal on the HEPAfilter is inserted
towards the inside of the vacuum cleaner.
The filter cover should be correctly oriented
when it is reattached. Do not reattach it upside down.
CLEANING THE SUB-FILTER
Clean the sub-filter when it becomes dirty.
Remove the dust compartment
1
(refer to page 8).
Remove the air inlet cover.
2
Remove the sub-filter from the vacuum cleaner.
3
Gently clean the sub-filter with water.
Make sure that it is completely dry and
4
then re-install it into the vacuum cleaner.
Replace the air inlet cover and the dust compartment.
Caution: Do not wash the air outlet filter and sub-filter in a washing machine, and do not
use any other equipment such as a hair dryer to dry it. Do not operate the vacuum
without the sub-filter. Be sure the filter is dry and properly installed. Failure to do
so could result in electrical shock, personal injury, or motor failure.
15
1
HEPA Filter
Filter Cover
1 1
2 2
Seal
2 2
Air Inlet
Cover
1 1
1 1
Sub-Filter