Limiter; Voice Fx - PRESONUS Revelator Dynamic Owner's Manual

Vintage 1970s EQ
1. EQ On/Off. Enables/disables the EQ globally. Touch to toggle on or off.
2. Low Frequency. Sets the shelving frequency for the Low Band.
3. Low Gain. Sets the Gain for the Low Band.
4. Low-Mid Frequency. Sets the center frequency for the Low-Mid Band.
5. Low-Mid Gain. Sets the Gain for the Low-Mid Band.
6. High-Mid Frequency. Sets the center frequency for the High-Mid Band.
7. High-Mid Gain. Sets the Gain for the High-Mid Band.
8. High Gain. Sets the Gain for the High Band.

7.2.6 Limiter

7.2.7 Voice FX

Your Revelator Dynamic is equipped with six Voice FX processors that can make your voice sound eth-
ereal, otherworldly, or just plain weird... your choice! This section will go through each effect in detail.
Note that while you can use any of these effects with the Fat Channel and Reverb, you can only use one
effect at a time.
7.2.6 Limiter
This encoder sets the threshold of the limiter for the selected channel
or output bus. When the signal's amplitude (level) exceeds the
threshold setting, the limiter is engaged. Turning the knob coun-
terclockwise lowers the threshold, so limiting begins at a lower amp-
litude. The Limiter ratio is ∞:1.
78