Changing The Signal Chain; Equalizer - PRESONUS Revelator Dynamic Owner's Manual

Professional dynamic usb mic for recording and streaming vocalists, podcasters, and more.

Table of Contents

threshold.

5. Release. Sets the time it takes for the compressor to stop attenuating a signal once it falls below the

threshold.

6. Ratio. Sets the Ratio for the compressor. The following Ratios are available: 4:1, 8:1, 12:1, 20:1, or

All.

7. Key Filter. This sets the frequency at which the compressor will engage. The compressor will still pro-

cess the entire frequency range, but it is only engaged when the specified frequency is present.

8. Key Listen. Press to listen to the signal being used to trigger the compressor,as set with the Key Fil-

ter control (including the effects of the high-pass filter). Press again to switch back to the normal chan-

nel signal.

7.2.4 Changing the Signal Chain

The Compressor and EQ can be reordered in the signal path. By default, the signal passes through the

compressor before passing through the EQ. When reordered, the EQ is placed before the compressor in

the signal path.

Power User Tip: Placing the compressor before the EQ allows you to make dramatic changes to the EQ set-

tings without needing to alter the compressor setting. However, if you place the EQ before the compressor, you

can better control different frequencies, achieving a more natural response.

As previously mentioned, an EQ (or equalizer) is a tone control that lets you make changes in the tonal

balance of a signal. You can boost or cut the level of ranges of frequencies, to make corrective or cre-

ative changes to the signal. Like the compressor, your Revelator Dynamic is equipped with three EQ

models from which to choose: Standard, Passive, and Vintage.

These distinct EQ models have their own set of controls and behavior:

Standard EQ. A clean and full-featured EQ that offers transparent tone shaping.

Passive Program EQ. A model of a tube-based EQ with simple, quick and a classic tonal character.

Vintage 1970s EQ. A model of a classic solid-state EQ, with simple, musical frequency settings and

a lot of character.

To change the EQ model, click on the dropdown menu. Note: The EQ will turn off whenever a new model

is loaded and must be re-enabled for you to hear its effect on your voice.

7.2.4 Changing the Signal Chain

Table of Contents