Sony ILCE-6400 Service Manual page 48

2-3-17. ST-1035 FLEXIBLE BOARD BLOCK
4 microphone block 4 microphone block
5 solder
[black]
5 solder
[orange]
: guide line
6 EM shield sheet (ST)
top side
qg MC base assy
Contact with
MC base assy.
qh maincon adhesive
sheet 0 to 0.5 mm
1 ST-1035 flexible board
5 solder 5 solder
[black] [orange]
8 Paste with adhesive sheet.
0 Paste with adhesive sheet.
7 Make a valley fold.
ST-1035 flexible board
rear side
0 to 0.5 mm
Note: The edge of the sheet must
polarity [–]
3 two solders
2 aluminium elect cap
qa Make a valley fold.
qd Make a valley fold.
9 Make a valley fold.
wa claw
trans
be between the pattern edges.
2-43
ILCE-6400/6400L/6400M
qs Make a mountain fold.
w; Insert the ST-1035 flexible
board into the inside of the
rib of the MC base assy.
qj Insert the ST-1035
flexible board into
the ditch of the MC
base assy.
qk Install the aluminium
elect cap in the MC
base assy.
ql Paste the aluminium
elect cap to the maincon
adhesive sheet.
: guide line
trans
0 to 1.0 mm
Fold.
qf FP protection
sheet (C)
SYS SET