Instructions For Use; Putting On The Antelope.suit; Putting On The Antelope.tank-Top; Connecting The Antelope.tank-Top And The Antelope.2C-Booster - Beurer ANTELOPE.8C-BOOSTER User Manual

8. INSTRUCTIONS FOR USE

NOTE
We recommend using ANTELOPE.Techwear at least once to max.
twice a week for 20 minutes. Between training sessions, suffi-
cient time for regeneration should be allowed. Before, during
and after your training you should drink enough water.

8.1 Putting on the ANTELOPE.SUIT

1. Open the three zippers of the ANTELOPE.SHIRT - one on
each side and one in the middle.
2. Put on the shirt and make sure that the electrodes lie flat on
your skin without folds or wrinkles.
3. Close the zippers.
4. Put on the ANTELOPE.SHORTS
NOTE
The electrodes must be placed directly onto the skin. Excessive
hair growth or extremely dry skin can affect the stimulation.
Ensure that the electrodes are placed directly on the targeted
muscle.
8.1.1 CONNECTING THE ANTELOPE.SUIT AND THE
ANTELOPE.8C-BOOSTER
DANGER
DO NOT CONNECT THE ANTELOPE.SUIT WITH ANTELOPE.
8C-BOOSTER IF THE BOOSTER IS TURNED ON.
ANTELOPE - part of the Beurer group - BEURER GmbH
1. On the back of the BOOSTER there is a grid of buttons. Hang-
ing from your ANTELOPE.SHORTS there is a connector with
buttons. To connect the two, place the shorts connector on
the lower-most buttons of the BOOSTER.
2. On the side of your ANTELOPE.SHIRT there is another grid of
buttons – this is the baseplate. To connect your shirt to the
BOOSTER, place the BOOSTER on the baseplate.

8.2 Putting on the ANTELOPE.TANK-TOP

1. Open the zippers on front and on each side of the TANK-TOP
2. Put on the TANK-TOP and make sure that the electrodes lie
flat on your skin without folds or wrinkles.
3. Close the zippers.
8.2.1 Connecting the ANTELOPE.TANK-TOP and the
ANTELOPE.2C-BOOSTER
DANGER
DO NOT CONNECT THE ANTELOPE.TANK-TOP WITH ANTELOPE.
2C-BOOSTER IF THE BOOSTER IS TURNED ON.
1. Connect the magnetic button ending of the external cables
to the magnetic buttons on the textile. One cable pair should
connect to the front buttons of the textile and the other pair
to the back.
2. Connect the jack plugs of the external cables to the jack plug
input at the bottom of the 2C-BOOSTER.
34